How to maintain the rotary joint on a daily basis

In daily maintenance, it is necessary to pay attention to the following aspects of the rotary joint to ensure its normal operation and extend its service life:

Maintain internal cleanliness:

When using rotary joints, special media will be generated, which will continuously accumulate inside and form a thick layer of material for a long time, affecting normal use.

Therefore, the rotating joint should be cleaned regularly, especially the inside of the drum and pipeline, to maintain its cleanliness.

For new equipment, filters should be installed to prevent foreign objects from causing abnormal wear on rotating joints.

Regular inspection of wear and tear:

Under normal circumstances, the wear range of the rotary joint is between five millimeters and ten millimeters.

If the degree of wear is found to be greater than this range, or if there is continuous wear or scratches, it is necessary to replace the rotary joint.

Continuing to use after severe wear and tear will have a serious impact on the installed equipment.

Check and record the work situation:

Before starting maintenance and repair, conduct a comprehensive inspection of the rotary joint and record its working condition.

This helps to understand the usage status of the joint, identify potential issues, and develop corresponding maintenance strategies.

Clean the surface of the rotary joint:

Thoroughly clean the surface of the rotary joint with a cleaning agent and brush to remove dirt and oil stains from the surface.

This helps to more conveniently check the condition of the joints and repair requirements.

Check the seals:

The seal in the rotary joint is a key component to prevent lubricating oil leakage and external pollutants from entering the joint.

Check the integrity of the seal and replace it promptly if any damage or aging is found.

Ensuring the quality of seals can improve the performance and service life of joints.

Pay attention to operational details:

During the operation, the rotating joint should be handled gently to avoid impact and foreign objects en